INSTALLATION OF HEATING COATINGS
- The G Therm paint is applied evenly between two parallel self-adhesive copper strips, the width of which can be from 20 to 30 mm.
- After the paint dries, the copper strips are connected to a GS PWM controller, which can be connected to any power supply of the required power and safe DC voltage up to 48 Volts.
- The GS PWM controller has the function of smoothly adjusting the heating power and can be controlled using a conventional room thermostat, a smart thermostat or a smart home system.
- The distance between the copper strips can be from 50 cm to 120 cm.
- The thickness of the copper strips should be at least 50 microns.
- After installation, the G Therm coating can be painted with any finishing paint.
- The G Therm coating can be installed under ceramic tiles, under a layer of plaster or under a concrete floor base.